63 Quarry — Accidents
Total: 16 accidents | Fatalities: 0
| Date | Classification | Injury | Days Lost | Narrative |
|---|---|---|---|---|
| 01/09/2026 | SLIP OR FALL OF PERSON | DAYS AWAY FROM WORK ONLY | None | Employee was helping with maintenance on the Norberg cone crusher. EE went to climb down the step ladder, the ladder shifted while still holding onto the cone with EE's left hand. Employee felt a pop... |
| 07/31/2025 | HANDTOOLS (NONPOWERED) | DAYS RESTRICTED ACTIVITY ONLY | 4d restricted | Employee was using carpenters knife to cut grease line when the knife slipped off the hose and cut left thumb knuckle. Did not require stitches, was placed in a splint to immobilize due to the locatio... |
| 08/17/2024 | SLIP OR FALL OF PERSON | ALL OTHER CASES (INCL 1ST AID) | None | Employee was adjusting the mirror on the dump truck when the employee's foot slipped off the step and EE struck right elbow on the storage box attached to the inside door panel. Incident became repor... |
| 04/04/2024 | MACHINERY | NO DYS AWY FRM WRK,NO RSTR ACT | None | Employee was using a wire wheel on a rusted piece of metal when employee felt something go into eye, underneath safety glasses. Employee flushed eye but still felt something in there. Went to clinic... |
| 09/28/2021 | HANDTOOLS (NONPOWERED) | DAYS RESTRICTED ACTIVITY ONLY | 9d restricted | Employee was cutting flashing from under a rock box with a folding carpenters knife and the knife folded on employee and cut palm |
| 04/05/2021 | OTHER | DAYS RESTRICTED ACTIVITY ONLY | 9d restricted | Employee got into dump truck to check fire extinguisher and stepped out of truck back on ground and felt lower back pinch. About 30 min. later EE shoveled off some build up on a screening unit and fel... |
| 08/25/2017 | HANDLING OF MATERIALS | DAYS RESTRICTED ACTIVITY ONLY | 31d restricted | The employee was placing a new section of culvert pipe on a existing culvert pipe. While placing the new sleeve the edge of the new pipe cut the employee on tip of the hand on knuckles. |
| 03/30/2015 | SLIP OR FALL OF PERSON | NO DYS AWY FRM WRK,NO RSTR ACT | None | The employee was climbing down a ladder when he got to the bottom and turned he felt a pop in his knee. Took him to the doctor and they thought he sprained it. After awhile it did not get better so we... |
| 10/06/2009 | MACHINERY | NO DYS AWY FRM WRK,NO RSTR ACT | None | EE had driven wedges between bucket and cutting edge while torching off bolts. The cutting edge sprang forward and caught the ee in the knee. This caused bruising and swelling in his knee later that e... |
| 06/03/2009 | HANDLING OF MATERIALS | DAYS RESTRICTED ACTIVITY ONLY | 2d restricted | Employee was holding a cylinder with his left hand. While trying to set it in place, cylinder hung up and became dislodged. This caused the cut to his hand. The cut to his hand required 6 stitches. |
| 02/12/2009 | DISORDERS (REPEATED TRAUMA) | OCCUPATNAL ILLNESS NOT DEG 1-6 | None | Employee stated that on the day of the hearing test he had a head cold which may have affected the results. He has been wearing proper hearing protection at work & does not believe he has been over-ex... |
| 05/10/2005 | DISORDERS (PHYSICAL AGENTS) | OCCUPATNAL ILLNESS NOT DEG 1-6 | 1d lost | HEAT EXHAUSTION - EE GOT DIZZY. |
| 11/29/2004 | HANDLING OF MATERIALS | NO DYS AWY FRM WRK,NO RSTR ACT | None | USING A LADDER TO PUT A BOLT IN AN IMPACTOR II, EMPLOYEE STRAINED HIS BACK. |
| 09/27/2004 | HANDTOOLS (NONPOWERED) | NO DYS AWY FRM WRK,NO RSTR ACT | None | Was cutting crown bar rubber for an screen deck and slipped and cut top of 2 fingers. |
| 07/30/2001 | HANDLING OF MATERIALS | DYS AWY FRM WRK & RESTRCTD ACT | 4d lost, 14d restricted | EMPLOYEE ALLEGES HE WAS HOOKING WELDER TO PICK UP. BENT DOWN TO LIFT UP HITCH AND FELT SHARP PAIN IN LOWER BACK. |
| 12/18/2000 | SLIP OR FALL OF PERSON | DAYS AWAY FROM WORK ONLY | 65d lost | EMPLOYEE WAS WALKING ACROSS ICE COVERED PIT FLOOR AND SLIPPED ON THE ICE. |