CENTRAL SERVICE — Accidents

Total: 12 accidents | Fatalities: 0

Date Classification Injury Days Lost Narrative
12/15/2014 OTHER DAYS RESTRICTED ACTIVITY ONLY 10d restricted Employee knelt down to put jack under rotor and when he stood up and felt sharp pain in lower back.
01/31/2014 SLIP OR FALL OF PERSON DAYS RESTRICTED ACTIVITY ONLY 10d restricted Employee was climbing down the forklift and rolled his right ankle on un-level ground.
05/07/2012 MACHINERY NO DYS AWY FRM WRK,NO RSTR ACT None IW was using a battery powered drill to drill a hole in a metal trough and as the drill bit cut through, it pulled his hand into the top of the trough cutting his index finger on this right hand.
09/05/2008 MACHINERY NO DYS AWY FRM WRK,NO RSTR ACT None Employee was drilling 1/8 inch metal plate with 3/4 inch drill bit on drill press. He needed to move holding clamp so bit would pass thru plate. While moving holding clamp and trying to align hole in...
10/01/2007 MACHINERY DAYS RESTRICTED ACTIVITY ONLY 64d restricted EE right thumb was crushed while trying to position a stack of plates on the vertical tilt band saw. When closing it the thumb was crushed between the hydraulic vise and the plate.
08/28/2006 HANDTOOLS (NONPOWERED) NO DYS AWY FRM WRK,NO RSTR ACT None EE was trying to dislodge a bearing from a shaft by using a hammer to tap on the bearing race as another employee heated the race. A small piece of metal broke off the race and entered EE forehead.
02/17/2005 HANDLING OF MATERIALS DAYS RESTRICTED ACTIVITY ONLY 4d restricted Strained back while replacing shaft bearing on a crane link belt.
12/27/2004 HANDLING OF MATERIALS DAYS AWAY FROM WORK ONLY 11d lost Employee was helping another employee wash parts, a spacer off of a 992C Cat Loader was on the bench beside the parts washer. The spacer fell off or was knocked off and hit the floor and then bounced...
08/15/2003 NO VALUE FOUND NO VALUE FOUND None EE WAS ASSISTING IN THE UNLOADING OF A CRUSHER. SUPERVISOR WAS OPERATING THE LINKBELT CRANE. THE CHAINS HOLDING THE CRUSHER CAME LOOSE AND BEGAN TO SWING IN A SPIRAL MOTION. SUPERVISOR VERBALL Y WARNE...
01/22/2003 HANDLING OF MATERIALS DAYS RESTRICTED ACTIVITY ONLY 9d restricted REPLACING TAIL PULLEY ON C-25: EE BENT DOWN TO RELEASE THE SLACK ON THE CONVEYOR BELT SO HE COULD LOOSEN THE COME-A-LONG THAT WAS HOLDING THE BELT CLAMPS. AT THIS POINT, EE FELT A SHARP PAIN G O DOWN...
10/16/2002 NONPOWERED HAULAGE DYS AWY FRM WRK & RESTRCTD ACT 56d lost, 14d restricted EE AND COWORKER WERE USING A HAND TRUCK TO TRANSPORT A STARTER CABINET FROM THE ELECTRICAL STORAGE AREA TO THE ELECTRICAL SHOP. THEY LOST CONTROL OF THE HAND TRUCK WHILE CORSSING A UNEVEN AREA ON THE...
08/07/2002 MACHINERY DYS AWY FRM WRK & RESTRCTD ACT 2d lost, 19d restricted EMPLOYEE WAS STANDING INSIDE OF 5 1/2 CRUSHER BOWL. HE WAS USING AIR CHISEL TO REMOVE OLD NORDBAK FROM FILLER BLOCKS, ONE OF THE BLOCKS CAME LOOSE AND FELL TO THE FLOOR AND OVER ON TO TOP OF E MPLOYEE...