Lowrys Quarry — Accidents

Total: 10 accidents | Fatalities: 0

Date Classification Injury Days Lost Narrative
01/29/2025 HANDTOOLS (NONPOWERED) NO DYS AWY FRM WRK,NO RSTR ACT None EE was using a 1/2-ton chain hoist to loosen a 24""x36"" screen panel from the center deck of screen deck #1. EE raised the corner of the panel a couple inches, while releasing the tension to reposit...
07/03/2024 POWERED HAULAGE NO DYS AWY FRM WRK,NO RSTR ACT None The injured employee was adjusting the belt scraper on C-6 conveyor. The belt was still in motion as EE attempted to adjust the scraper and this caused the spud wrench to forcefully be spun back caus...
06/04/2007 MACHINERY DAYS RESTRICTED ACTIVITY ONLY 106d restricted Technician inspecting mobile crane and unaware of boom position in regards to positioning of technician's hand. Boom was retracted and sliding section of boom injured technician's hand. Cuts to fing...
02/09/2007 HANDLING OF MATERIALS NO DYS AWY FRM WRK,NO RSTR ACT None Employee was performing maintenance on a heater fan & motor. The heater started to tip over and he reached to grab it and his left little finger was caught between the blade & the sheet metal housing...
04/25/2006 STEPPING OR KNEELING ON OBJECT DAYS RESTRICTED ACTIVITY ONLY 46d restricted On Thursday 4/27/06 employee was taken to doctor and it was determined that he had a sprain of his left ankle. He stated his left foot slipped off a rock and turned his ankle.
05/20/2005 HANDTOOLS (NONPOWERED) DAYS RESTRICTED ACTIVITY ONLY 19d restricted Employee was using a 5 foot pry bar to pry the rocks loose from the chute when a rock came down and hit his finger against the pry bar, fracturing his left middle finger.
02/17/2005 MACHINERY DAYS RESTRICTED ACTIVITY ONLY 8d restricted Employee was cutting a bolt with a torch. Torch brushed across the employee's finger and burned through glove, causing a second degree burn to the employee's left middle finger.
06/11/2004 HANDTOOLS (NONPOWERED) NO DYS AWY FRM WRK,NO RSTR ACT None Supervisor was holding a box wrench on the bolt heads of the tube assembly of a Telsmith Screen while another employee was tightening the nuts on the opposite side with a ratchet when the Supervisor's...
11/15/2003 HANDLING OF MATERIALS NO DYS AWY FRM WRK,NO RSTR ACT None EE WAS INSTALLING A NEW TAIL PULLEY WHEN HIS LEFT INDEX FINGER WAS CAUGHT BETWEEN THE PULLEY SHAFT & CONVEYOR FRAME. MEDICAL ATTENTION REQUIRED STERI-STRIPS & A FINGER SPLINT. EE RETURNED TO W ORK, PE...
01/10/2000 HANDTOOLS (NONPOWERED) NO DYS AWY FRM WRK,NO RSTR ACT None THE EE WAS CHANGING A TOOTH ON HIS LOADER. HE USED A HAMMER TO HIT THE TOOTH AND LOSING IT UP. WHEN HE HIT THE TOOTH ON THE POINT END A CHIP CAME OFF AND HIT HIM IN HIS LEFT UPPER ARM BICEP.