Luck Stone Atlanta Stephens Plant — Accidents
Total: 28 accidents | Fatalities: 0
| Date | Classification | Injury | Days Lost | Narrative |
|---|---|---|---|---|
| 09/22/2025 | HANDLING OF MATERIALS | DAYS RESTRICTED ACTIVITY ONLY | 44d restricted | While working to replace a cylinder on a motor grader, the associate pulled the cylinder back to realign it & pinched EE's finger between the cylinder block & the frame of the motor grader. |
| 11/18/2023 | HANDTOOLS (NONPOWERED) | NO DYS AWY FRM WRK,NO RSTR ACT | None | Associate was replacing some rubber with a safety knife. As the associate was scoring the bucking rubber the safety knife kept getting stuck. They squeezed the handle 3 more times, & on the 3rd attemp... |
| 06/07/2023 | HANDTOOLS (NONPOWERED) | DAYS RESTRICTED ACTIVITY ONLY | 42d restricted | ASSOCIATE WAS REPLACING A TOOTH ON A CONCRETE MUNCHER. WHILE HOLDING THE RETAINING PIN WITH LEFT HAND & SWINGING A HAMMER WITH THE RIGHT, EE GLANCED OFF THE PIN & HIT LEFT HAND. |
| 04/25/2023 | POWERED HAULAGE | DAYS AWAY FROM WORK ONLY | 161d lost | An EE was operating the Cat skid steer, as EE was backing up, the skid steer and the Dingo IE was operating made contact. |
| 03/08/2022 | FIRE | ACCIDENT ONLY | None | Fire detected by evening cleaning crew in shop. Hot work being performed on the haul truck earlier in the day could have been a factor. |
| 02/10/2022 | HANDLING OF MATERIALS | DAYS RESTRICTED ACTIVITY ONLY | 9d restricted | Associate came up to the metal yard to pick up a couple pieces of metal for a chute rebuild. As they started sliding the large angle iron off the sheet of metal they needed, they lost track of their s... |
| 02/07/2022 | SLIP OR FALL OF PERSON | DAYS AWAY FROM WORK ONLY | 159d lost | BECAME REPORTABLE ON 2/15/2022 WHEN EE HAD TO ATTEND PHYSICAL THERAPY While climbing down from haul truck, boot lug caught & caused EE to lose EE's grip with EE's left hand & grabbed with right hand c... |
| 03/10/2021 | HANDTOOLS (NONPOWERED) | DAYS AWAY FROM WORK ONLY | 24d lost | When cutting a lifting eye in the welding shop, EE knocked the center piece free with a chipping hammer, the hot metal fell on EE's pant leg, burned through the material and fell into the top of EE's... |
| 11/02/2020 | HANDTOOLS (NONPOWERED) | DAYS AWAY FROM WORK ONLY | 14d lost | Associate was attempting to dislodge a rock from a conveyor with a 24"" bar. The associate's hand got pinned between the bar & the conveyor. |
| 07/07/2020 | POWERED HAULAGE | DAYS RESTRICTED ACTIVITY ONLY | 16d restricted | While operating a manlift from one location to another, driver hit a dip that caused driver to bounce up with left foot landing on the material in the basket resulting in a sprain to calf from the twi... |
| 11/11/2019 | SLIP OR FALL OF PERSON | DAYS AWAY FROM WORK ONLY | 2d lost | While walking to the truck for tools & supplies, EE walked through a wet & muddy area & slipped, causing EE to fall on knee. |
| 08/30/2019 | SLIP OR FALL OF PERSON | DAYS AWAY FROM WORK ONLY | 2d lost | While working to flip a jaw dye at the Granite Plant, EE hopped out of the crusher and was walking on the surrounding catwalk when EE's boot slipped and EE's leg extended forward, causing pain in knee... |
| 06/06/2019 | MACHINERY | DYS AWY FRM WRK & RESTRCTD ACT | 5d lost, 221d restricted | When moving a crane from work area, our associate began to raise the crane unaware that one of the hooks from a two-way chain had become lodged under the flange of a beam. This created tension on the... |
| 05/01/2017 | HANDLING OF MATERIALS | NO DYS AWY FRM WRK,NO RSTR ACT | None | Employee was removing a drive belt when employee's right pinky was caught between the pulley & belt. The injury caused a hematoma to the tip of finger, X-rays were negative for fracture/break |
| 09/12/2016 | HANDLING OF MATERIALS | NO DYS AWY FRM WRK,NO RSTR ACT | None | 3 7/16"" by 60"" shaft resting on 8x8x16"" wood block to allow grinding of end. Shaft rolled off block striking left middle finger when employee tried to stop shaft. Left hand middle finger received c... |
| 08/21/2014 | HANDTOOLS (NONPOWERED) | DAYS RESTRICTED ACTIVITY ONLY | 16d restricted | Employee was on ground wielding lifting eyes on Jaw Cheek plates. The plates were stacked on top of each other and as he would finish wielding one he would slide the plate off to the side. During this... |
| 06/24/2014 | POWERED HAULAGE | DAYS AWAY FROM WORK ONLY | 254d lost | Employee was completing his normal daily task of cleaning around conveyor 19 when he heard a noise coming from a return roller. Employee reached up to a return roller to remove a rock. The return roll... |
| 06/05/2014 | HANDLING OF MATERIALS | DAYS RESTRICTED ACTIVITY ONLY | 4d restricted | Crane was lifting a 60ft section of truss conveyor with two spreader bars equally spaced for balance. C-clamps were attached to spreader to prevent movement of truss. One clamp slipped allowing the... |
| 11/14/2013 | HANDTOOLS (NONPOWERED) | NO DYS AWY FRM WRK,NO RSTR ACT | None | Employee was preparing a cable belt for splicing by using a hook knife as recommended by the manufacturer to perform that process. The hook knife slipped off the cable, and forward momentum carried t... |
| 09/12/2013 | STEPPING OR KNEELING ON OBJECT | DAYS RESTRICTED ACTIVITY ONLY | 45d restricted | Employee was climbing down ladder at cone crusher when he stepped on a rock at the base of ladder twisting his right ankle. |
| 07/28/2012 | HANDLING OF MATERIALS | DAYS AWAY FROM WORK ONLY | 47d lost | In preparation for painting a new conveyor, one end was resting on a cross-tie and the other end was raised by placing fork lift forks under a tail pulley. As the conveyor was raised to install block... |
| 07/11/2011 | DISORDERS (PHYSICAL AGENTS) | OCCUPATNAL ILLNESS NOT DEG 1-6 | 2d lost, 1d restricted | Employee blacked-out and appeared to have a seizure while working on a excavator in 93 degree heat. |
| 06/27/2011 | SLIP OR FALL OF PERSON | DAYS AWAY FROM WORK ONLY | 1d lost | Employee fell off 4' retaining wall while cleaning conveyor chute and suffered a lumbar strain/ back contusion |
| 05/25/2011 | HANDTOOLS (NONPOWERED) | NO DYS AWY FRM WRK,NO RSTR ACT | None | Employee was using a come-a-long to pull two I beams together while wielding a cross beam. The anchor point broke and the come-a-long popped back and hit his right hand. |
| 05/12/2011 | MACHINERY | DAYS AWAY FROM WORK ONLY | 3d lost | The employee was walking by the boom truck when the hook struck him on the right side in the ribs. |
| 10/15/2010 | HANDLING OF MATERIALS | DAYS AWAY FROM WORK ONLY | 26d lost | Employee was removing grizzly bars. When he removed a pin, the bars fell striking him in the side of the face and neck. |
| 05/17/2010 | SLIP OR FALL OF PERSON | DAYS AWAY FROM WORK ONLY | 280d lost | Employee was preparing to place platform in place for stacker. Employee stepped close to edge of one block, which was four feet from concrete floor. A 10 inch by 22 inch piece of concrete block brok... |
| 01/07/2008 | SLIP OR FALL OF PERSON | DAYS AWAY FROM WORK ONLY | 1d lost | Miner cleaning windows on haul truck. He slipped on a truck step and twisted his knee. |