Monahans — Accidents
Total: 16 accidents | Fatalities: 0
| Date | Classification | Injury | Days Lost | Narrative |
|---|---|---|---|---|
| 01/09/2025 | HANDTOOLS (NONPOWERED) | DAYS RESTRICTED ACTIVITY ONLY | 21d restricted | Employee was tracking a conveyor belt on the return side of the conveyor using a small sledge hammer to adjust the return rollers. Employee missed EE's target and smashed EE's middle finger tip, resul... |
| 12/02/2024 | HANDLING OF MATERIALS | DAYS RESTRICTED ACTIVITY ONLY | 3d restricted | Employee was positioning a diesel heater into place after fueling. As EE released the handles and went to stand up, EE felt EE's back slip and a numbing sensation in EE's lower back and leg. |
| 08/12/2024 | SLIP OR FALL OF PERSON | NO DYS AWY FRM WRK,NO RSTR ACT | None | Third Party Truck Driver pulled up to outbound safety rack, truck was too far forward. CSP employee instructed Driver that the Driver had to back truck up to use the rack, Driver refused to move truc... |
| 05/28/2024 | POWERED HAULAGE | NO DYS AWY FRM WRK,NO RSTR ACT | None | Employee driving a haul truck descended down a ramp in the pit/mine. Driver did not notice cross ruts from the previous shift. Employee drove through the ruts and was slammed into the window, resultin... |
| 03/10/2024 | HANDLING OF MATERIALS | NO DYS AWY FRM WRK,NO RSTR ACT | None | Employee was assisting in installing a tail pulley guard after replacing the conveyor belt. While trying to line up the bolt holes, the guard shifted and pinched left pinky finger, requiring stitches. |
| 08/29/2023 | SLIP OR FALL OF PERSON | DYS AWY FRM WRK & RESTRCTD ACT | 1d lost, 7d restricted | Employee was topping off the auto greaser on an excavator. The employee was struggling to disconnect the fill line and jerked on it, causing EE to lose footing and fall to the ground. The fall resulte... |
| 05/09/2023 | HANDTOOLS (NONPOWERED) | DAYS RESTRICTED ACTIVITY ONLY | 22d restricted | Employee was changing a tail pulley bearing. The all thread part of the take up was ceased up. Once the all thread broke free, while using a break away bar, the employee's left middle finger was mashe... |
| 05/01/2023 | HANDLING OF MATERIALS | NO DYS AWY FRM WRK,NO RSTR ACT | None | Two employees were replacing guarding on the side of a conveyor. The guard slipped and pinched the left index finger between the guard and frame work, resulting in need of stitches. |
| 04/06/2021 | HANDLING OF MATERIALS | DAYS RESTRICTED ACTIVITY ONLY | 1d restricted | Employee was assisting in changing the diester springs and pinched their left middle finger between the spring and diester frame. |
| 12/22/2020 | SLIP OR FALL OF PERSON | DYS AWY FRM WRK & RESTRCTD ACT | 279d lost, 22d restricted | Employee was walking to the break room after clocking in. Lost footing and fell. |
| 07/02/2020 | SLIP OR FALL OF PERSON | DAYS RESTRICTED ACTIVITY ONLY | 14d restricted | Employee lost footing after refilling the printer, causing a loss of balance and falling. The employee caught all their weight on their right arm which resulted in a fracture. |
| 10/26/2019 | SLIP OR FALL OF PERSON | DAYS RESTRICTED ACTIVITY ONLY | 84d restricted | Employee ascended a fixed vertical ladder to inspect an agitation tank. On the way back down, feet slipped off the ladder rung and fell. |
| 05/02/2019 | HANDLING OF MATERIALS | DAYS RESTRICTED ACTIVITY ONLY | 29d restricted | Employee was doing maintenance on Dryer-100 where employee smashed the tip of thumb between a steel plate and drive chain. |
| 04/30/2019 | SLIP OR FALL OF PERSON | DAYS RESTRICTED ACTIVITY ONLY | 22d restricted | While walking on scale, employee lost balance and twisted knee. |
| 03/21/2019 | HANDTOOLS (NONPOWERED) | NO DYS AWY FRM WRK,NO RSTR ACT | None | The employee was cutting tape off of motor leads to the disconnect fan. EE then cut the right thumb to the back side of EE's hand. The cut required stitches. |
| 10/24/2018 | HANDLING OF MATERIALS | DAYS RESTRICTED ACTIVITY ONLY | 16d restricted | Miner was assisting in the removal of a HDPE pipe from wet-processing equipment. As the pipe was being lifted, the load shifted, pinching the miner's right thumb between the load and the equipment's s... |