Santan Pit — Accidents
Total: 14 accidents | Fatalities: 0
| Date | Classification | Injury | Days Lost | Narrative |
|---|---|---|---|---|
| 12/06/2025 | SLIP OR FALL OF PERSON | NO DYS AWY FRM WRK,NO RSTR ACT | None | Had gone to get a tool, walking across the concrete pad between the crush and feeder, fell off the concrete slab. When EE fell EE scaped right knee, ripped my pants and scaped my knee. |
| 07/31/2025 | HANDTOOLS (NONPOWERED) | NO DYS AWY FRM WRK,NO RSTR ACT | None | Employee standing on the 6X catwalk cutting crown rubber to place in 6X shaker. Finger in glove in it ended up in the path of the blade, cut through Maxo flex gloves |
| 07/21/2025 | SLIP OR FALL OF PERSON | DAYS AWAY FROM WORK ONLY | 3d lost | Tried to get down from haul truck, missed step fell on right hip and hit back of head on the ground. |
| 02/11/2025 | HANDTOOLS (NONPOWERED) | DAYS AWAY FROM WORK ONLY | 4d lost | Employee had tied EE's sweater with a zip tie and used a blade for cutting. When EE was cutting EE pointed the blade toward EE's body and cut EE's hand. EE should have pointed the blade away from body... |
| 08/12/2021 | SLIP OR FALL OF PERSON | NO DYS AWY FRM WRK,NO RSTR ACT | None | Walking up to wash plant between the 1/2"" belt and 3/4"" belt and walked under 7X20 shaker slowly because of algae build up on concrete floor, slipped and fell back, hitting head. Got up and saw bloo... |
| 04/09/2020 | MACHINERY | NO DYS AWY FRM WRK,NO RSTR ACT | None | Doing a liner change, installing wear plates on inside of tub of the K400 crusher, EE was in bottom of tub aligning wear plate. A jack was installed from cone head to the wear plate to get it ready fo... |
| 02/22/2019 | HANDLING OF MATERIALS | NO DYS AWY FRM WRK,NO RSTR ACT | None | EE went to the wash plant to look for some rubber boots. In the floc room ee found them located at the bottom shelf: there was a spray bar laying across. With left hand ee held on to the shelf and pul... |
| 11/10/2016 | OTHER | INJURIES INVOLVNG NONEMPLOYEES | None | Not an EE, incident occurred inside plant's property line. An EE noticed fire, thinking it was a brush fire, then noticed a vehicle halfway engulfed with fire. Called 911 and fire dept. and safety ma... |
| 07/01/2016 | HANDTOOLS (NONPOWERED) | NO DYS AWY FRM WRK,NO RSTR ACT | None | While cutting a 48 inch length rail rubber down to 45 inches, employee held the rail rubber with left hand. EE made the cut with a utility knife with right hand and over cut the rail rubber into work... |
| 01/05/2013 | MACHINERY | NO DYS AWY FRM WRK,NO RSTR ACT | None | Employee was grinding when the grinder hit a burr and jumped and knicked left arm. |
| 09/09/2010 | HANDTOOLS (NONPOWERED) | NO DYS AWY FRM WRK,NO RSTR ACT | None | Employee was removing rail clamp inside of 8x20 Primary screen using a pry bar when bar slipped and struck employee on the right side of his face causing a laceration above his lip. |
| 12/19/2008 | HANDLING OF MATERIALS | DAYS AWAY FROM WORK ONLY | 5d lost | Employee claimed he hurt his wrist climbing down from truck on 12-19. He did not report until 12-22. Said he would be off 2 weeks. Our Dr. returned him to work to drive truck on 12-31. Investigation... |
| 05/02/2008 | HANDLING OF MATERIALS | DAYS AWAY FROM WORK ONLY | 64d lost | Employee was stockpiling sand with a 980 loader. He felt a pain his back. He reported to his supervisor but did not want medical help. On 5/12/08 he went to the hospital with back pains. He was plac... |
| 09/30/2003 | HANDLING OF MATERIALS | DYS AWY FRM WRK & RESTRCTD ACT | 1d lost, 59d restricted | EE WAS BEGINNING A WORK AREA EXAM WHEN HE WALKED UP TO THE REPAIR AREA, WHEN HE NOTICED MECHANICS HAVING TROUBLE W/GEAR BOX AS THEY WERE MANUALLY LIFTING & LINING GEAR BOX ONTO SHAFT, SO HE ST OOD BET... |