Tata Chemicals Mine — Accidents
Total: 666 accidents | Fatalities: 0
| Date | Classification | Injury | Days Lost | Narrative |
|---|---|---|---|---|
| 03/02/2010 | FALL OF ROOF OR BACK | NO DYS AWY FRM WRK,NO RSTR ACT | None | EE was drilling a hole in the roof for a bolt when a piece of rock broke off striking his left foot causing a laceration. |
| 02/15/2010 | HOISTING | ACCIDENT ONLY | None | #3 hoist tripped on ""Drive Converter A"" fault. Electrician was called out of the mine to inspect and reset the hoist. There were still two remaining escape ways throughout the incident (#2 and #6... |
| 02/06/2010 | HOISTING | ACCIDENT ONLY | None | The #3 production hoist tripped on ""Check Point UHM"" and ""Drive Converter A"" faults. Electrician was called out of the mine to inspect the hoist and reset the faults. The hoist was back in servi... |
| 01/27/2010 | HOISTING | ACCIDENT ONLY | None | It was reported that the north hoist motor for #3 hoist was making noise. Upon investigating, it was determined that something was rubbing on the inside of the motor so the hoist was shut down for in... |
| 01/23/2010 | HANDTOOLS (NONPOWERED) | DAYS AWAY FROM WORK ONLY | 1d lost | EE was cutting a piece of hose with a utility knife when he slipped and cut his finger. |
| 01/17/2010 | FALL OF ROOF OR BACK | NO DYS AWY FRM WRK,NO RSTR ACT | None | EE was taking steel out of the hole he drilled for a roof bolt when chunks of trona fell down striking him on his left hand. |
| 01/10/2010 | HOISTING | ACCIDENT ONLY | None | #3 hoist tripped on ""#4 West Brake Not Applied"" fault. Maintenance foreman, electrician, and mechanic were called out of the mine. The brake was checked and adjusted and the hoist was inspected an... |
| 01/09/2010 | HOISTING | ACCIDENT ONLY | None | #3 production hoist tripped on ""Drive Converter A"" fault. Maintenance coordinator and electrician were called out of the mine to check the hoist out and reset the hoist. There were still two remai... |
| 01/02/2010 | HOISTING | ACCIDENT ONLY | None | #2 hoist tripped on ""Supervision"" fault. Maintenance Coordinator and Electrician reset the fault and inspected the hoist. There were still two escapeways throughout the incident. |
| 12/26/2009 | HANDLING OF MATERIALS | NO DYS AWY FRM WRK,NO RSTR ACT | None | EE was taking bottom roller out of FCT roadway, when the roller shifted and caught her thumb between roller and bracket. She received stitches on her thumb. |
| 12/21/2009 | HOISTING | ACCIDENT ONLY | None | #3 hoist tripped on ""Drive Converter A"" and ground fault. Electrician was called out of the mine to check the hoist and reset the faults. Electrician closed a window in the hoist penthouse to prev... |
| 12/17/2009 | HOISTING | ACCIDENT ONLY | None | #3 hoist tripped on ""Drive Converter A"" fault. Maintenance foreman and electrician were called out of the mine to check the hoist and reset the fault. There were still two remaining escapeways thr... |
| 12/17/2009 | HOISTING | ACCIDENT ONLY | None | #3 hoist tripped on ""Drive Converter A"" and ""Vibration"" faults. Maintenance foreman and electrician were called out of the mine to check the hoist and reset the faults. There were still two rema... |
| 12/15/2009 | HOISTING | ACCIDENT ONLY | None | Hoistman lost computer communication to the #2 hoist. A breaker had tripped and had to be reset and the hoist had to be re-synced. The hoist was back in service at 3:05 PM. There were still two rem... |
| 12/15/2009 | HOISTING | ACCIDENT ONLY | None | #3 hoist tripped on ""Drive Converter A"" and ""Vibration"" faults. Maintenance Foreman and electrician were called out of the mine to check the hoist and reset the faults. There were still two rema... |
| 12/14/2009 | HOISTING | ACCIDENT ONLY | None | #3 hoist tripped on ""East Motor Bearing Overtemp"" fault. Maintenance foreman and electrician were called out of the mine to check the hoist and reset the hoist. There were still two remaining esca... |
| 12/10/2009 | HOISTING | ACCIDENT ONLY | None | #3 hoist tripped on ""Vibration"" fault. Electrician and maintenance foreman came out of the mine and inspected and reset the hoist. Hoist was back in service at 11:15 PM. Hoist tripped two more ti... |
| 12/06/2009 | HOISTING | ACCIDENT ONLY | None | #3 hoist tripped on ""Vibration fault. Electrician and maintenance coordinator came out of the mine and inspected and reset the hoist. Hoist was back in service at 4:50 AM. There were still two rem... |
| 12/05/2009 | HOISTING | ACCIDENT ONLY | None | #3 hoist tripped on ""Vibration"" fault. Electrician and maintenance coordinator came out of the mine and inspected and reset the hoist. Hoist was back in service at 3:30 AM. There were still two r... |
| 11/30/2009 | HOISTING | ACCIDENT ONLY | None | #3 hoist tripped on ""Drive Converter A"" fault and ""Vibration"" fault. Maintenance Coordinator and electrician were called out of the mine to check and reset the hoist. The hoist was back in servi... |
| 11/26/2009 | HOISTING | ACCIDENT ONLY | None | Hoist tripped on ""Drive Converter A"" and ""East Motor Overtemp"" faults. Electricians and maintenance foreman were called out of the mine to check and reset the hoist. The hoist was back in servic... |
| 11/24/2009 | HANDLING OF MATERIALS | DAYS AWAY FROM WORK ONLY | 133d lost | Employee was hanging secondary cable when the cable came down and struck him on the head. |
| 11/24/2009 | IGNITION OR EXPLOSION OF GAS OR DUST | ACCIDENT ONLY | None | Bore miner operator went to turn up the face fan and upon returning noticed a floor bleeder that had been ignited under the FCT. The FCT operator grabbed a fire extinguisher and extinguished the floo... |
| 11/19/2009 | STEPPING OR KNEELING ON OBJECT | DYS AWY FRM WRK & RESTRCTD ACT | 3d lost, 25d restricted | EE stepped out of LHD and stepped on a rock, straining his RT knee. EE reinjured it on 12/3/09. |
| 11/18/2009 | POWERED HAULAGE | NO DYS AWY FRM WRK,NO RSTR ACT | None | Employee was driving on roadway when she got distracted and struck the rib and lacerated her lip. |
| 11/09/2009 | HANDTOOLS (NONPOWERED) | DYS AWY FRM WRK & RESTRCTD ACT | 3d lost, 11d restricted | Employee was changing bits on a miner. When he pushed hard on the wrench, he felt a rip in his left shoulder. He will have surgery on 11/30/09. |
| 11/07/2009 | HANDLING OF MATERIALS | DYS AWY FRM WRK & RESTRCTD ACT | 9d lost, 105d restricted | Employee was pulling on a miner nip. Cable had a twist in it and when it came untwisted, it twisted his L shoulder. |
| 10/30/2009 | HANDLING OF MATERIALS | NO DYS AWY FRM WRK,NO RSTR ACT | None | Employee was walking by the fct. He put his hand on a box of the fct and a rock fell from the back striking his hand and splitting it open. |
| 10/28/2009 | HOISTING | ACCIDENT ONLY | None | # 3 hoist tripped on low brake air pressure caused by a breaker problem on transformer. Breaker was replaced and hoist was back in service at 4:53am. There were still two escapeways throughout the inc... |
| 10/18/2009 | HOISTING | ACCIDENT ONLY | None | #2 hoist had electrical problems on the 250 volt side. Electrician was brought out of the mine to troubleshoot and repair. Hoist was back in service @5:45pm. There were still two escape ways during in... |
| 10/04/2009 | OTHER | DYS AWY FRM WRK & RESTRCTD ACT | 94d lost, 23d restricted | EE was getting ready to wash out the conveyor while he was holding the water hose he asked for the water to be turned on. When the wrong hose was turned on he turned to get away from it and twisted hi... |
| 09/30/2009 | HOISTING | ACCIDENT ONLY | None | Hoist tripped on ""Drive Converter A"" and ""Vibration"" faults. Electrician inspectd teh hoist and reset the faults and hoist was back in service at 5:20 AM. There were still two escapeways during in... |
| 08/15/2009 | FALL OF ROOF OR BACK | NO DYS AWY FRM WRK,NO RSTR ACT | None | While bolting, employee was struck with a rock causing a small laceration and contusion to his left arm. |
| 08/11/2009 | POWERED HAULAGE | DAYS RESTRICTED ACTIVITY ONLY | 9d restricted | While watering the roads U/G, ee hit a rough part of the road and jarred his back. |
| 08/05/2009 | HOISTING | ACCIDENT ONLY | None | During a storm a lightening strike caused the main power source to the plant to trip causing a total power outage tripping both the #2 & #3 hoists. The emergency backup generator was brought on line t... |
| 07/21/2009 | HOISTING | ACCIDENT ONLY | None | #3 hoist kicked on ""East Motor #1 Bearing Overtemp"" fault. Still had two escapeways during the incident. |
| 06/05/2009 | HOISTING | ACCIDENT ONLY | None | #3 hoist tripped at 7:45 pm with ""Drive converter a"" fault. Electrician came out of the mine and repaired a contactor and reset the hoist. Hoist was back in service at 9:00 pm. There were still two... |
| 05/29/2009 | STEPPING OR KNEELING ON OBJECT | DYS AWY FRM WRK & RESTRCTD ACT | 1d lost, 45d restricted | Employee was stepping out of the Lotrac. In doing so employee stepped on a rock, twisting his right ankle. |
| 05/18/2009 | HOISTING | ACCIDENT ONLY | None | There was an issue with a breaker on the ""B drive"" on #3 hoist. Electrician changed the breaker and the hoist was back in service at 12:10 pm. There were still two escapeways throughtout the inciden... |
| 05/16/2009 | HOISTING | ACCIDENT ONLY | None | #3 hoist kicked out on drive converter a fault. Electrician was called out of the mine to check and reset the hoist. Hoist was back in service at 8:30 am. there were a still two escapeways throught ou... |
| 05/08/2009 | SLIP OR FALL OF PERSON | DYS AWY FRM WRK & RESTRCTD ACT | 72d lost, 20d restricted | Employee was stepping out of jeep when he tripped on a rock and sprained his left knee. Employee worked through the 11th and was placed on light duty on May 12th. |
| 05/06/2009 | HOISTING | ACCIDENT ONLY | None | After performing regular scheduled servicing on #3 hoist, the hoist tripped on ""drive converter A"" fault upon startup. The hoist was checked out and reset and back in service at 10:35am. There were... |
| 05/01/2009 | HOISTING | ACCIDENT ONLY | None | Dispatcher lost computers. Upon investigation, it was determined that the line that provides power to #2 & #3 hoists had somehow lost power so #2 & #3 hoists were down. At that point a mne evacuation... |
| 04/30/2009 | HOISTING | ACCIDENT ONLY | None | #3 hoist tripped on an ""EMS Fault"". Electrician had to be called out of the mine to check and reset the hoist. Hoist was back in service at 4:15 am. There were still two separate escapeways during t... |
| 04/28/2009 | HANDTOOLS (NONPOWERED) | NO DYS AWY FRM WRK,NO RSTR ACT | None | Employee was pulling slack out of come-along when chain came unhooked causing come-along to strike employee in mouth and chipping three teeth. |
| 04/25/2009 | HANDLING OF MATERIALS | NO DYS AWY FRM WRK,NO RSTR ACT | None | Employee was removing a piece of rock from the miner when he smashed his left pinkie between the rock and the miner. |
| 04/24/2009 | HOISTING | ACCIDENT ONLY | None | #3 hoist tripped when the #4 west brake did not actuate. The brake solenoid was replaced and the hoist was back in service at 10:05 AM. There were still two operable hoists/escapeways throughout the i... |
| 04/10/2009 | HANDTOOLS (NONPOWERED) | DYS AWY FRM WRK & RESTRCTD ACT | 9d lost, 24d restricted | Employee was changing out a bit on the miner with a bit wrench when his right thumb got caught between the wrench and the bit resulting in a broken thumb. |
| 04/01/2009 | MACHINERY | NO DYS AWY FRM WRK,NO RSTR ACT | None | Employee turned his head to find a bolt when the drill rolled off the block, pinching his left 5th finger. He had blood drained from nailbed. |
| 03/31/2009 | HOISTING | ACCIDENT ONLY | None | At 9:50pm, #3 hoist tripped on east motor #2 overtemp. After looking at hoist, it was determined that a bearing needed to be changed. The bearing was changed and hoist was back in service at 2:00 am.... |